Side Impact Sensor (Second) Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.


NOTE: Wait at least 3 minutes before starting work.

3. Side Impact Sensor (Second) - Remove


1.
Disconnect the connector (A).

2.
Remove the bolt (B), then remove the side impact sensor (second) (C).

4. All Removed Parts - Install

1.
Install the all removed parts in the reverse order of removal.

NOTE:
During installation, install the new bolt to the specified torque.
Before installing the rear door sill trim, make sure the SRS indicator works normally.

5. SRS Operation - Confirm

1.
Do the 12 volt battery terminal reconnection procedure, turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.