DTC Troubleshooting: C1850-12 (44-12)
DTC C1850-12: Fail Safe Relay Stuck ON
NOTE: Before you troubleshoot, review the General Troubleshooting Information.

DTC Description
DTC
Freeze Frame
C1850-12 Fail Safe Relay Stuck ON
   

1.
Problem verification:

Problem verification
?1.
Turn the vehicle to the ON mode.

?2.
Check the parameter(s) below with the HDS.
Signal
Threshold
Current conditions
Values
Unit
Values
Unit
Voltage of Battery
More than 8.3
V
   

Do the current condition(s) match the threshold?

     
YES
     
     
     
The failure is duplicated. Go to step 2.
     
NO
     
     
     
Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the Freeze data/on-board snapshot.?
2.
Real time AWD relay check:

Real time AWD relay check
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.

Is the real time AWD relay OK?

     
YES
     
     
     
The real time AWD relay is OK. Go to step 3.
     
NO
     
     
     
3.
Shorted wire check (E-DPS COIL- line):

Shorted wire check (E-DPS COIL- line)
?1.
Disconnect the following connector.
Real time AWD control unit 24P connector

?2.
Check for continuity between test points 1 and 2.
Test condition
Vehicle OFF (LOCK) mode
 
Real time AWD relay: disconnected
 
Real time AWD control unit 24P connector: disconnected
Test circuit
E-DPS COIL-
Test point 1
Real time AWD relay 4P socket No. 4
Test point 2
Body ground


Is there continuity?

     
YES
     
     
     
Repair a short to ground in the E-DPS COIL- wire between the real time AWD relay and the real time AWD control unit.?
     
NO
     
     
     
The E-DPS COIL- wire is OK. Go to step 4.
4.
Shorted wire check (E-DPS PWR line to power):

Shorted wire check (E-DPS PWR line to power)
?1.
Turn the vehicle to the ON mode.

?2.
Measure the voltage between test points 1 and 2.
Test condition
Vehicle ON mode
 
Real time AWD relay: disconnected
 
Real time AWD control unit 24P connector: disconnected
Test circuit
E-DPS PWR
Test point 1
Real time AWD relay 4P socket No. 2
Test point 2
Body ground


Is there about 0.1 V or less?

     
YES
     
     
     
Update the real time AWD control unit if it does not have the latest software, or substitute a known-good real time AWD control unit, and recheck. If the symptom/indication goes away with the updated real time AWD control unit, troubleshooting is complete. If the symptom/indication goes away with a known-good real time AWD control unit, replace the original real time AWD control unit.?
     
NO
     
     
     
Repair a short to power in the E-DPS PWR wire between the real time AWD relay and the real time AWD control unit.?