CVT Differential Carrier Bearing Outer Race Replacement
Special Tools Required
Image Description/Tool Number
310169.png Driver Handle, 15 x 135L 07749-0010000
310194.png Attachment, 78 x 90 mm 07GAD-SD40101
310163.png Bearing Driver Attachment, 72 x 75 mm 07746-0010600

NOTE:
The carrier bearing and the carrier bearing outer race should be replaced as a set.
Replace the carrier bearing with a new one whenever the carrier bearing outer race is replaced.
Adjust the carrier bearing preload after replacing the carrier bearing and the carrier bearing outer race.
Apply a light coat of clean transmission fluid on all parts before installation.
Unless otherwise indicated, illustrations used in the procedure are for AWD/4WD.

Transmission Housing Side

2. Differential Carrier Bearing Outer Race - Remove

1.
Remove the carrier bearing outer race (A) and the 41 x 92 x 1 mm spacer (B) by heating the transmission housing to about 212 °F (100 °C) using a heat gun (C).

NOTE: Do not heat the transmission housing more than 212 °F (100 °C).

3. Differential Carrier Bearing Outer Race - Install


1.
Install the 41 x 92 x 1 mm spacer (A) by aligning the tab (B) with the groove (C).

2.
Place a new carrier bearing outer race (D).





3.
Drive the carrier bearing outer race securely using the 15 x 135L driver handle and the 78 x 90 mm attachment so there is no clearance between the carrier bearing outer race, the 41 x 92 x 1 mm spacer, and the transmission housing.

Torque Converter Housing Side

2. Differential Carrier Bearing Outer Race - Remove

1.
Remove the carrier bearing outer race (A), the 41 x 76.2 x 1 mm spacer (B), and the 76 mm thrust shim (C) by heating the torque converter housing to about 212 °F (100 °C) using a heat gun (D).

NOTE: Do not heat the torque converter housing more than 212 °F (100 °C).

3. Differential Carrier Bearing Outer Race - Install


1.
Install the 76 mm thrust shim (A).

2.
Install the 41 x 76.2 x 1 mm spacer (B) by aligning the tab (C) with the groove (D).

3.
Place a new carrier bearing outer race (E).





4.
Drive the carrier bearing outer race securely using the 15 x 135L driver handle and the 72 x 75 mm bearing driver attachment so there is no clearance between the carrier bearing outer race, the 41 x 76.2 x 1 mm spacer, the 76 mm thrust shim, and the torque converter housing.