Cut the adhesive tape (A) along the rear edge of the door lower trim (B) with a utility knife while separating the trim from the door (C) with a trim tool.
NOTE: Apply protective tape (D) around the cutting area as shown.
3.
Cut the adhesive tape (A) along the upper edge of the door lower trim (B) with a utility knife while separating the trim from the door (C) with a trim tool.
NOTE: Apply protective tape (D) around the cutting area as shown.
4.
Slide the door lower trim (A) forward and remove it.
NOTE: The clips (B, C) will stay in the door.
5.
Remove the clips by turning them 45°.
6.
Install the clips on the door lower trim.
1.
Rear Door Lower Trim - Install
1.
If you are reusing the original door lower trim (A), apply primer to the areas where new double-sided adhesive tape (B, C, and D) will be applied, then attach the new double-sided adhesive tape to the trim as shown.
Adhesive tape (B):
Thickness 1.2 mm (0.047 in)
Width 8 mm (0.31 in)
Length 68 mm (2.68 in)
Adhesive tape (C):
Thickness 1.5 mm (0.059 in)
Width 6 mm (0.24 in)
Length 555 mm (21.85 in)
Adhesive tape (D):
Thickness 1.6 mm (0.063 in)
Width 10 mm (0.39 in)
Length 114 mm (4.49 in)
2.
Install the screw (A) securing the clip (B) to the door lower trim (C). Hold up the trim, and first set clip B into the hole in the door (D). Fit the clips (E) into the hole in the door, then push on the trim.