|
LaneWatch Symptom Troubleshooting - Does not switch to the LaneWatch screen
Does not switch to the LaneWatch screen
|
1. |
LaneWatch camera check:
LaneWatch camera check
|
?2. |
Go into the System Diagnostic Mode, and select the Detail Information & Setting.
|
|
?3. |
Select LaneWatch in the Unit Check. | |
Is the Connection OK?
|
2. |
LaneWatch switch check:
LaneWatch switch check
|
?1. |
Select Return, then select LaneWatch in the Functional Setup. |
|
?2. |
Operate the LaneWatch switch. | |
Is the LaneWatch switch OK?
|
|
|
Intermittent failure, the system is OK at this time.? |
|
|
|
|
|
3. |
Open wire check (LWC SW line):
Open wire check (LWC SW line)
|
?1. |
Turn the vehicle to the OFF (LOCK) mode. |
|
?2. |
Disconnect the following connector.
|
LaneWatch switch (combination light switch) 12P connector | |
| |
|
?3. |
Turn the vehicle to the ON mode. |
|
?4. |
Go into the System Diagnostic Mode, and select the Detail Information & Setting.
|
|
?5. |
Select LaneWatch in the Functional Setup. |
|
?6. |
Connect terminals A and B with a jumper wire.
|
Terminal A |
LaneWatch switch (combination light switch) 12P connector No. 4 |
|
Terminal B |
Body ground | |
| | |
Is the LaneWatch Switch turned on?
|
|
|
The LWC SW wire is OK. Go to step 4. |
|
|
|
Repair an open in the wire between the LaneWatch switch (combination light switch) and the audio/audio-navigation unit.? |
|
4. |
Open wire check (GND line):
Open wire check (GND line)
|
?1. |
Connect terminals A and B with a jumper wire.
|
Terminal A |
LaneWatch switch (combination light switch) 12P connector No. 3 |
|
Terminal B |
LaneWatch switch (combination light switch) 12P connector No. 4 | |
| | |
Is the LaneWatch Switch turned on?
|
|
|
|
|
|
|
Repair an open in the wire between the LaneWatch switch (combination light switch) and the body ground at G501.? |
|
5. |
Shorted wire check (LWC VCC line) 1:
Shorted wire check (LWC VCC line) 1
|
?1. |
Turn the vehicle to the OFF (LOCK) mode. |
|
?2. |
Disconnect the following connectors.
|
LaneWatch camera 6P connector | |
| |
|
?3. |
Turn the vehicle to the ON mode. |
|
?4. |
Measure the voltage between test points 1 and 2.
|
Test condition |
Vehicle ON mode |
| |
LaneWatch camera 6P connector: disconnected |
|
Test point 1 |
LaneWatch camera 6P connector No. 4 |
|
Test point 2 |
Body ground | |
| | |
Is there about 8 V?
|
|
|
The LWC VCC wire is OK. Go to step 6. |
|
|
|
|
|
6. |
Open wire check (LWC SH line):
Open wire check (LWC SH line)
|
?1. |
Turn the vehicle to the OFF (LOCK) mode. |
|
?2. |
Check for continuity between test points 1 and 2.
|
Test condition |
Vehicle OFF (LOCK) mode |
| |
LaneWatch camera 6P connector: disconnected |
|
Test point 1 |
LaneWatch camera 6P connector No. 3 |
|
Test point 2 |
Body ground | |
| | |
Is there continuity?
|
|
|
The LWC SH wire is OK. Go to step 7. |
|
|
|
Repair an open in the wire between the LaneWatch camera and the audio/audio-navigation unit.? |
|
7. |
Shorted wire check (LWC TO UNIT, UNIT TO LWC line) 1:
Shorted wire check (LWC TO UNIT, UNIT TO LWC line) 1
|
?1. |
Turn the vehicle to the OFF (LOCK) mode. |
|
?2. |
Disconnect the following connectors.
|
Audio/audio-navigation unit connector G (24P) | |
| |
|
?3. |
Check for continuity between test points 1 and 2.
|
Test condition |
Vehicle OFF (LOCK) mode |
| |
LaneWatch camera 6P connector: disconnected |
| |
Audio/audio-navigation unit connector G (24P): disconnected |
|
Test point 1 |
LaneWatch camera 6P connector No. 5 |
|
Test point 2 |
Body ground | |
|
|
Test point 1 |
LaneWatch camera 6P connector No. 2 |
|
Test point 2 |
Body ground | |
| | |
Is there continuity?
|
|
|
Repair a short to bodyground in the wire between the LaneWatch camera and the audio/audio-navigation unit.? |
|
|
|
|
|
8. |
Shorted wire check (LWC TO UNIT, UNIT TO LWC line) 2:
Shorted wire check (LWC TO UNIT, UNIT TO LWC line) 2
|
?1. |
Check for continuity between test points 1 and 2.
|
Test condition |
Vehicle OFF (LOCK) mode |
| |
LaneWatch camera 6P connector: disconnected |
| |
Audio/audio-navigation unit connector G (24P): disconnected |
|
Test point 1 |
LaneWatch camera 6P connector No. 2 |
|
Test point 2 |
LaneWatch camera 6P connector No. 5 | |
| | |
Is there continuity?
|
|
|
Repair a short in the wire between the LaneWatch camera and the audio/audio-navigation unit.? |
|
|
|
|
|
9. |
Open wire check (LWC TO UNIT, UNIT TO LWC line):
Open wire check (LWC TO UNIT, UNIT TO LWC line)
|
?1. |
Check for continuity between test points 1 and 2.
|
Test condition |
Vehicle OFF (LOCK) mode |
| |
LaneWatch camera 6P connector: disconnected |
| |
Audio/audio-navigation unit connector G (24P): disconnected |
|
Test point 1 |
LaneWatch camera 6P connector No. 2 |
|
Test point 2 |
| |
|
|
Test point 1 |
LaneWatch camera 6P connector No. 5 |
|
Test point 2 |
| |
| | |
Is there continuity?
|
|
|
|
|
|
|
Repair an open in the wire between the LaneWatch camera and audio/audio-navigation unit.? |
|
10. |
Shorted wire check (LWC VCC line) 2:
Shorted wire check (LWC VCC line) 2
|
?1. |
Turn the vehicle to the OFF (LOCK) mode. |
|
?2. |
Disconnect the following connectors.
|
Audio/audio-navigation unit connector G (24P) | |
| |
|
?3. |
Check for continuity between test points 1 and 2.
|
Test condition |
Vehicle OFF (LOCK) mode |
| |
LaneWatch camera 6P connector: disconnected |
| |
Audio/audio-navigation unit connector G (24P): disconnected |
|
Test point 1 |
LaneWatch camera 6P connector No. 4 |
|
Test point 2 |
Body ground | |
| | |
Is there continuity?
|
|
|
Repair a short in the wire between the LaneWatch camera and the audio/audio-navigation unit.? |
|
|
|
|
|
11. |
Open wire check (LWC VCC line):
Open wire check (LWC VCC line)
|
?1. |
Check for continuity between test points 1 and 2.
|
Test condition |
Vehicle OFF (LOCK) mode |
| |
LaneWatch camera 6P connector: disconnected |
| |
Audio/audio-navigation unit connector G (24P): disconnected |
|
Test point 1 |
LaneWatch camera 6P connector No. 4 |
|
Test point 2 |
| |
| | |
Is there continuity?
|
|
|
|
|
|
|
Repair an open in the wire between the LaneWatch camera and the audio/audio-navigation unit.? | |