Remove the cover (A), then disconnect the rear safing sensor connector (B) on the floor wire harness.
2.
Remove the bolt (C), then remove the rear safing sensor (D).
6.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE:
During installation, install the new bolt to the specified torque.
Before installing the rear safing sensor cover, make sure the SRS indicator works normally.
7.
SRS Operation - Confirm
Do the 12 volt battery terminal reconnection procedure, turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.