LKAS Switch Removal, Installation, and Test

SRS components are located in this area. Review the SRS component locations, and the precautions and procedures before doing repairs or service.

2. LKAS Switch - Remove

1.
Remove the steering wheel rear cover (A).






2.
Remove the switch cover (A).

3.
Remove the HFL switch (without navigation) or HFL-navigation voice control switch (with navigation) (B).






4.
Remove the switch cover (A).

5.
Remove the multi-information switch (B).





6.
Remove the steering wheel trim (A).





7.
Remove the LKAS switch (A).

3. All Removed Parts - Install

1.
Install the parts in the reverse order of removal.

1. LKAS Switch - Test


1.
Measure the resistance between terminals No.2 and No. 5 in each switch position according to the table.

Position
Resistance
No button pressed
About 2.2 k?
MAIN
About 60 ?
CANCEL
About 180 ?
RES/?
About 900 ?
SET/?
About 450 ?

2.
Measure the resistance between terminals No.3 and No. 4 in each switch position according to the table.

Position
Resistance
No button pressed
About 2.2 k?
LKAS
About 60 ?

3.
If the resistance is not as specified, replace the LKAS switch.