Slide the automatic lighting/rain sensor (B), then remove it.
3.
Disconnect the connector.
4.
Remove the silicon sheet (A).
NOTE:
Do not reuse the silicon sheet.
If there is no rain sensor silicon sheet on the back, it will remain in the glass surface. Please make sure peel off.
1.
Silicon Sheet - Replace
NOTE:
Never touch the primed surface on the automatic lighting/rain sensor with your hands.
Do not put on the silicon sheet out of automatic lighting/rain sensor.
Be careful not to touch the silicon sheet surfaces, make sure it is clean. keep it away from dust.
1.
Remove the protective sheet A from the silicon sheet (C).
2.
Hold the protective sheet B, then set and put silicon sheet on position (D) to the automatic lighting/rain sensor (E).
3.
Remove the protective sheet B.
2.
Automatic Lighting/Rain Sensor - Install
NOTE:
If the automatic lighting/rain sensor connector is connected after the 12 volt battery terminal is connected, the automatic lighting/rain sensor is not confirmed by MICU.
If the MICU does not confirm the automatic lighting/rain sensor, automatic wiper system does not work.
Connect the automatic lighting/rain sensor connector first, then connect the battery terminal.
1.
Connect the connector (A).
2.
Install the automatic lighting/rain sensor (B) to the bracket (C), and slide the automatic lighting rain sensor to upward then lock the stopper (D).
